[ 3 / a / adv / an / asp / cgl / ck / co / diy / fa / g / gd / int / jp / k / lit / m / mlp / mu / n / o / out / p / po / sci / sp / tg / toy / trv / tv / v / vg / vp / vr / w / wsg / x]

/3/ - 3DCG

<< back to board
[Delete this thread]

File: curves.gif-(305 KB, 471x344)
Semi-beginner here.Why is this...
Anonymous 02/20/14(Thu)12:35 UTC+1 No.410829 Report

Semi-beginner here.

Why is this happening? Modeling in Maya 2014 using Nurbs curves and everytime i go over this isoparm it flips around, but it does not happen on the exact opposite of the sphere nor when crossing any other isoparms.
>>
Anonymous 02/20/14(Thu)13:31 UTC+1 No.410833 Report

>>410829
because NURBS cannot be closed. A sphere may look like a sphere but actually there is an edge that defines where it starts and where it ends.
Might be related to that
>>
Anonymous 02/20/14(Thu)17:10 UTC+1 No.410847 Report

>>410833


zhisss.

>>410829

you shold try to move the cut into area where it will not be cuted. or you have to use projection
All the content on this website comes from 4chan.org. All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster. 4chanArchive is not affiliated with 4chan.